WizGear Universal Air Vent Magnetic Car Mount Holder Black

Setting your phone on a mount in your car has never been easier! WizGear Air Vent Car Mount for smartphones saves you the hassle of placing your smartphone securely to make sure it doesn’t fall just push it in the air vent! The WizGear Air Vent Mount features a magnetic technology, which means your smartphone will be secure and have no chance of falling. When a phone is secure in place, it becomes easier to use for GPS navigation too.

1) This magnetic car mount for cell phones is not bulky or space consuming at all. You no longer have to suffice for keeping your phone in the cup holder or dashboard, because a normal car mount gets in the way. This magnetic car mount inserts into the Air Vent, thereby not blocking your windshield.

2) Navigation is extremely easy with this magnetic car mount. It can easily rotate, fix, or tilt to any angle that best assists the viewer of the phone.

3)The magnetic technology is safe to use, and will not harm any smartphone. The carbon steel plates inside the magnetic car mount are ultra thin and designed in a way that it provides powerful holding power as well as absorbing magnetic instability. Along with being safe, it is also powerful, it attracts any phone to it quickly – this is the auto-mount feature. The user can just bring the phone near the mount and it will take it easily, so the user no longer has to fuss about with safekeeping their phone

Instructions how to set up the Mount
1)Insert the mount in the Air Vent Mount in your car.
2)Place the magnet metal plate in your case between the cover and the phone, Or stick on the round magnet metal on your phone or GPS
3) And your phone is go to go!!

2 thoughts on “WizGear Universal Air Vent Magnetic Car Mount Holder with Fast Swift-Snap Technology for Smartphones and Mini Tablets, Black

  1. Phillip D. Breske says:

    Pretty good, but not great. Better than a lot of other solutions. I bought two of these, one for each car. One of them holds a little tighter to the A/C vent because the rubber-covered “fork” is slightly tighter (see photo). Luckily, one car has vent louvers that are a little thicker than the other, so it worked out. If you have only one car and the fork does’t grab the louvers tight enough, you can try squeezing the forks in a vise (I suggest using some kind of plastic or rubber vise plates to avoid damaging the rubber on the magnet forks). I did this to get the looser one to hold better and it worked a little, but it was never as good as the one that came tighter from the factory. Neither of these holds strong enough to stay attached to the vent louver when the phone is pulled off unless you slide the phone to one side or the other—pulling straight off will usually pull the WizGear with it.The magnet is actually four rare earth magnets (probably neodymium) in an array under the rubber cover (see photo). They are very…

Leave a Reply